A4 V6-3.0L (AVK) (2004)
Throttle Position Sensor: Service and Repair
Accelerator Pedal Module W/TPS For Accelerator Pedal Position
Accelerator Pedal Module With Throttle Position (TP) Sensor-G79- And Sender -2- For Accelerator Pedal Position -G185-, Removing And
Installing
-
Remove driver-side storage compartment.
-
Disconnect 6-pin harness connector -2-.
-
Remove bolts -1- and -3-.
-
Remove accelerator pedal module.
Installing
Installation is the reverse of removal, noting the following:
-
In a vehicle with automatic transmission, the kickdown function must be adapted when accelerator pedal module is replaced: To do so, switch on
ignition and press accelerator pedal all the way down past the kickdown point and hold in position for at least 20 seconds.
-
Switch ignition off.
-
Engine Control Module (ECM) now requires approx. 3 seconds to store the learned value. At this time, the ignition must not be switched on
again
Tightening torque
Component
Nm
Accelerator pedal module at pedal mount
10