A4 V6-3.0L (AVK) (2004)
Battery: Testing and Inspection
No Load Voltage Measurement
No Load Voltage Measurement
Special tools and equipment
-
V.A.G 1526 A
CAUTION
-
The battery plugs must be fully tightened when charging, measuring voltage or performing load tests.
-
Make sure that following notes are observed otherwise correct measurements cannot be guaranteed.
NOTE:
-
If no load voltage measurement is carried out with the battery installed in vehicle, it is absolutely necessary to disconnect Ground strap.
-
The battery must not be loaded by connected power consumers for at least 2 hours before making measurements.
-
The battery must not be charged for at least 2 hours before making measurements.
Sequence of operations
See Caution for disconnecting Telematics battery
-
For vehicles with coded radio / radio-navigation system obtain radio code before disconnecting battery.
-
Push cover over battery to the right -arrow 1- and remove by lifting off -arrow 2-.