A4 V6-3.0L (AVK) (2004)
Steering Gear: Service and Repair
Power Steering Gear, Removing and Installing
Power steering gear, removing and installing
Removing
-
Remove plenum chamber cover.
CAUTION!: Before beginning repairs on the electrical system:
^
Obtain the anti-theft radio security code.
^
Switch the ignition off.
^
Disconnect the battery Ground (GND) strap.
^
On vehicles equipped with Audi Telematics by OnStar, switch-off the emergency (backup) battery for the Telematic/Telephone Control
Module prior to disconnecting vehicle battery.
^
After reconnecting vehicle battery, re-code and check operation of anti-theft radio. Also check operation of clock and power windows
according Owner's Manual.
^
After reconnecting vehicle battery on vehicles equipped with Audi Telematics by OnStar, switch-on the emergency (backup) battery for the
Telematic/Telephone Control Module
-
Remove battery if necessary.
WARNING! Move steering wheel to center position and do not turn it while performing repair work, as otherwise coil connector of
airbag unit could be damaged.
-
Pull out ignition key with steering wheel in center position.
-
Move steering wheel slightly to engage steering lock.
-
Removing driver's storage compartment
-
Loosen bolt -arrow-.
Tightening torque: 30 Nm
-
Secure steering column to stop it sliding apart
Note:
^
Always install new sealing collar if collar is damaged.
^
Make sure sealing collar is properly positioned.
-
Pinch off suction and return lines with hose clamps -3094-.
-
Unbolt front wheels.