A4 V6-3.0L (AVK) (2004)
Tie Rod End: Service and Repair
Tie rod end, removing and installing
Removing
-
Remove wheel
-
Loosen and take out bolt -1-.
Tightening torque: 5 Nm
-
Unfasten hex nut -5- and take out bolt -2-.
Always replace self-locking nut.
Tightening torque: 50 Nm
Note: Never widen slots in wheel bearing housing using a chisel or similar implement.
-
Press tie rod downward.
-
Loosen hex nut -3- and unbolt tie rod end.
Hex -4- at axial joint is designed to provide support.
Tightening torque: 40 Nm
-
Remove grease from tie rod end and clamping hole at wheel bearing housing.
Installing
Install in reverse order of removal and note the following:
Perform wheel alignment following installation.
-
Check wheel alignment.
-
Tighten clamping nut -5- to 50 Nm.
-
Tighten hex bolt -1- to 5 Nm.