A4 V6-3.0L (AVK) (2004)
-
Remove drive axle.
-
Position transmission lifter VAG 1383/A under engine/transmission (danger of accident due to parts falling out when wheel hub and wheel bearing
are removed).
Pulling out wheel hub
-
Install bell -1-, hollow piston cylinder -2- with tie bolt and special nut -3-.
-
Pull out hub by actuating pump, holding device fast.
1. Bell E-40
2. Hollow piston cylinder HKZ-15
3. Special nut E-8-214 and tie bolt
Pulling out wheel bearing
-
Install pressure piece -1- with collar facing bearing, thrust sleeve -2- with four-step ID facing wheel bearing housing and hollow piston cylinder -3-
with tie bolt and special nut -4-.
-
Pull out wheel bearing by actuating pump.
1. Pressure piece E-5
2. Thrust sleeve E-44-1
3. Hollow piston cylinder HKZ-15
4. Special nut E-8-214 and tie bolt
Pressing in wheel bearing
Installation position: Large ID of wheel bearing faces outward.
-
Install wheel bearing -1-, pressure piece -2- (insert collar in bearing) and hollow piston cylinder -3- to wheel bearing housing with tie bolt.
-
Install pressure piece -4- from inside with chamfered edges facing wheel bearing housing and special nut -5-.
-
Press in wheel bearing by actuating pump.
1. Wheel bearing
2. Pressure piece E-14-1
3. Hollow piston cylinder HKZ-15