A4 V6-3.0L (AVK) (2004)
Clutch Release Bearing: Service and Repair
6 SPD. M/T 01E
Clutch release mechanism, servicing
1 - Transmission
2 - Intermediate piece
^
Replace, if damaged
3 - Shaft seal
^
For input shaft
^
Removing
^
Installing
^
Standard insertion depth: 3.5 mm, insertion depth for repairs: 4.5 mm
4 - Locating sleeve
5 - Bolt - 15 Nm
^
3 pieces
6 - Clutch release lever
^
Removing
^
Must engage in lugs in intermediate piece when installed
^
Before installing, coat contact surface of clutch slave cylinder push rod with copper grease, e.g. Z 381 351 TE.
7 - Leaf spring
8 - Release and tighten bolt - 25 Nm
^
Self-locking
^
Always replace
9 - Release bearing
^
With or without plastic ring, depending on version
^
Cement detached plastic ring
^
Do not wash out, wipe clean only
^
Replace noisy bearings