A4 V6-3.0L (AVK) (2004)
-
Drive in new oil seal for left-hand flange shaft to a depth of 5.5 mm below outer surface of cover using 2062, keep seal straight when installing.
Note: If the old flange shaft is reinstalled after the repair, the oil seal must be driven in to a depth of approximately 6.5 mm so that the new seal
does not run on the same contact surface as the old one.
^
Knock flange shaft in with drift VW 295.
^
Install drive shaft.
^
Check oil level in front final drive.
Tightening torque