A4 V6-3.0L (AVK) (2004)
Axle Shaft Assembly: Service and Repair
Component Overview
Component overview
Types and grease specifications of tripod drive axle:
Outer joint:
^
98 mm diameter - G 000 633
^
Triple roller joint - G 000 605
Re-grease joint when replacing CV boot.
1. Clamp
^
Always replace
^
Tightening - Go to Fig. 1
^
There may be different clamps, depending on construction, also mountable using 3340 pliers.
Different versions - Go to see parts catalog.
2. CV boot for tripod joint
^
CV boot must make contact in groove and contour of joint piece.
3. Clamp
^
Always replace
^
Tightening - Go to Fig 1
4. Snap ring
^
Depending on version - Go to see parts catalog
5. Dished washer
^
Installation position - Go to Fig. 4
^
Depending on version - Go to see parts catalog
6. Spacer ring (plastic)
^
Installation position - Go to Fig. 4
^
Depending on version - Go to see parts catalog
7. Snap ring
^
Always replace
^
Insert in ring groove of shaft before installation (not visible on installed joint)