A4 V6-3.0L (AVK) (2004)
/Page-3154002.png)
-
Install securing ring.
1- Pliers (commercially available)
-
Press 70 grams of G 000 605 drive axle grease from repair set into back of triple roller joint.
-
Lightly grease roller body.
Make sure roller bodies do not tilt.
-
Press joint piece over tripod star using a plastic mallet.
-
Press remaining amount of grease into CV boot.
Note:
^
Make sure boot is properly seated on joint piece.
^
Boot must make contact in the groove and the contour of the joint piece.
-
Position joint piece in center position. See min - max position.
Note: Ventilate C V boot, e.g. using a screwdriver, while positioning joint piece in center position (arrow).
-
Mount clamp.
Note: Position the crimping tab -2- of the clamp between mounting flanges -1- of joint piece. This will facilitate threading the socket head bolts
during installation of the drive axle
-
Tighten small clamp using VAG1275 pliers.
