A4 V6-3.0L (AVK) (2004)
Front Door Window Regulator: Service and Repair
Front Window Frame and Window Regulator
Window Frame And Window Regulator, Removing And Installing
1
-
Window frame
-
Removing:
-
Remove door trim. Body Interior.
-
Disconnect electrical harness connectors.
-
Remove window regulator motor.
-
Remove bolts - 7 -.
-
Remove bolts - 4 -, - 8 - and - 10 -.
-
Remove bolts - 6 - and - 9 - and lift window frame with window regulator upward and out of door.
-
Installation:
-
Drive window into window frame halfway before installing.
-
Insert window frame and window regulator into door from above.
-
Knock in the upper profile halves of door-side gasket into window frame at top.
-
Loosely screw in mounting bolts in the sequence - 6 - ;- 9 - ;- 3 - ;- 8 - and - 10 -.
-
Tighten collared shoulder bolts - 6 - and - 9 - hand tight.
-
Lightly press window frame - 1 - inward at top.
-
Tighten bolts - 4 - and - 8 - to 32 Nm.
-
Tighten collared shoulder bolts - 6 - and - 9 - to 32 Nm.
-
Tighten bolt - 10 - to 10 Nm.
-
Tighten locating bolt - arrows - in window frame to 32 Nm.
2
-
Window regulator
-
Bolted to window frame for installing in door.
3
-
Front door
4
-
Torx screw
-
32 Nm
5
-
Concealment cap