A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
/Page-505002.png)
4. Connecting rod bearing cap
^
Mark cylinder number -B-
^
Installed position: Marking -A- must face toward pulley end
5. Bearing shell
^
Note installed position
^
Do not interchange used bearing shells (mark)
^
Make sure that bearing shell is seated correctly in retaining lugs
^
Axial clearance, New: 0.10...0.35 mm; Wear limit: 0.40 mm
^
Check radial clearance with Plastigage, New: 0.01...0.05 mm; Wear limit: 0.12 mm
^
Do not rotate crankshaft when checking radial clearance
^
To measure radial clearance, tighten nut -1- to 30 Nm but not further
