A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
/Page-568006.png)
-
Remove M10 bolts (arrows).
-
Loosen bolts -1 to 18- in diagonal sequence.
Note: Use T10058 for bolts -17- and -18-.
Note: Remove both rear oil pan bolts -1- and -2- using socket attachment 3249 or T10058. On vehicles with manual transmission, do this by turning
flywheel -3- until recess (arrow) is aligned with bolt.
-
Remove oil pan. If necessary, loosen by tapping lightly using a rubber hammer.
-
Remove baffle plate and carefully remove sealant remaining on cylinder block.
-
Remove remaining sealant from oil pan with rotating plastic brush or similar.
WARNING: Wear safety goggles.
-
Clean sealing surfaces. They must be free of oil and grease.
Installing
Install in reverse order, paying attention to the following:
