A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
-
To disconnect, press release button on connection piece
-
Do not bend
-
Clipped in on fuel tank
6. Seal
-
Always replace
-
To install, place into opening of fuel tank dry
7. Locking ring
-
Use ring nut wrench 3087 to remove and install
-
Tighten to 145 Nm
8. Electrical harness connector
-
For Fuel Level Sensor 2 -G169-
-
Disengaging, see Fig. 1
9. Connector flange
-
Only available together with -item 10-
-
Installation position
10. Fuel Level Sensor 2 -G169-
-
Only available together with -item 9-
11. Suction jet pump
-
With lines
-
Different versions, allocation
-
Secured on connector flange
12. Fuel delivery line
-
From suction jet pump, right side
Fig. 1 Releasing harness connector
-
To disconnect the multi-pin harness connector at Fuel Pump (FP), the harness connector must be released. This can be done by hand or by using a
small screwdriver (arrow).
Removing and installing fuel pump
CAUTION: To remove the Fuel Pump (FP), the fuel tank may only be filled to a maximum of 1/4. Empty fuel tank if necessary.
Recommended special tools and equipment
-
3087 wrench for tank sensor