A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
-
Clipped in on fuel tank
7. Electrical harness connector
-
For Fuel Pump (FP) and sender for fuel gauge -G-
-
Disengaging, see Fig. 1
8. Locking ring
-
Use ring nut wrench 3087 to remove and install
-
Tighten to 145 Nm
9. Suction jet pipe
-
To disconnect, press release button on connection piece
10. Suction jet pump
Fig. 1 Releasing harness connector
-
To disconnect the multi-pin harness connector at Fuel Pump (FP), the harness connector must be released. This can be done by hand or by using a
small screwdriver (arrow).
Removing and installing fuel pump
CAUTION: To remove the Fuel Pump (FP), the fuel tank may only be filled to a maximum of 3/4. Empty fuel tank if necessary.
Recommended special tools and equipment
-
3087 wrench for tank sensor
-
VAS5190 fuel siphoning device