A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
Headlamp Alignment Actuator: Service and Repair
Headlight Beam Adjusting Motors, Removing And Installing
Removing
-
Remove headlight.
-
Remove housing cover from headlight housing.
-
Remove bolts -arrows-.
-
Push out ball head of adjustment axle by swinging adjusting motor -2- to the side out of ball head mount.
-
Disconnect electrical harness connector -1-.
Installing
Installation is reverse of removal, paying attention to the following:
-
Install headlight.
NOTE: Always adjust headlights after adjusting motors are removed and installed or are replaced.
Tightening torque
Component
Nm
Adjusting motor for vertical headlight beam
control to headlight housing
1. 2