A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
Impact Sensor: Service and Repair
Front Side Airbag Crash Sensor, Removing and Installing
Front Side Airbag Crash Sensor, Removing And Installing
CAUTION: Observe safety precautions for working on airbag on airbag.
-
Removing
-
Disconnect battery Ground (GND) strap.
-
Remove side trim.
-
Remove belt reel of front seat belt.
-
Remove belt reel insulation.
-
Remove bolts - 2 - (2x).
-
Tightening torque 9 Nm
-
Disconnect connector on crash sensor - 1 - and remove crash sensor - 1 -.
-
Installing
-
Install crash sensor - 1 - in reverse order of removal.
-
Switch ignition on.
CAUTION: There must be no one in the vehicle when the battery is being connected.
-
Connect battery Ground (GND) strap.
NOTE:
-
After connecting the battery observe the necessary measures.
-
If Airbag Malfunction Indicator Lamp (MIL) K75 signals a malfunction after assembly, use vehicle diagnostic, testing and information
system VAS 5051 A to interrogate, erase and then again interrogate DTC memory.