A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
/Page-1529001.png)
Multiple Junction Connector: Service and Repair
Connection Point, E-Box In Plenum Chamber, Removing and Installing
Connection Point, E-Box In Plenum Chamber, Removing And Installing
Removing
NOTE: All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
-
Remove driver's storage compartment:
-
Unbolt the electrical cable at bottom of connection point, E-Box in plenum chamber.
-
Remove rubber seal for plenum chamber cover.
-
Remove plenum chamber cover -1- toward front -arrows-
-
Use a screwdriver to pry off the two caps -3-.
-
Loosen hex nuts -4- by several turns.
-
Loosen wiper arm -2- from wiper axle by lightly tilting.
-
Remove hex nuts completely and remove wiper arms.
-
Disconnect securing clips -1- and remove cowl panel grill -5-
-
Remove cover for E-box, plenum chamber -arrows-
