A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
/Page-1529002.png)
-
Using a screwdriver, pry off retaining bar -arrow-.
-
Set aside Engine Control Module (ECM) with cables connected.
-
Unclip Transmission Control Module (TCM) retaining bracket.
-
Set aside Transmission Control Module (TCM) with cables still connected.
-
If present, cut through cable ties.
-
Disconnect connectors at rear of connector rail.
-
Unscrew wire connection -2-.
-
Remove bolts -1- and -3-.
-
Unclip the corresponding connector base.
NOTE: Check the exact assignment for connection point E-Box plenum chamber in the current wiring diagram.
Installing
Installation is reverse of removal, paying attention to the following:
NOTE: All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
Tightening torques
Component
Nm
Connection point, E-Box plenum
3
chamber to center tube for
instrument panel
