A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
Installing rear bonded rubber bush
-
Insert two shell sections -3372/2- between bridge piece -3351/4- and subframe.
-
Pull in bush as far as the stop.
Apply corrosion protection if paint surface on subframe is damaged.
Installing front bonded rubber bush
Use lubricating oil G 294 421 A1 when pressing in bonded rubber bushes.
-
Insert 3372/2 split bushings in - 3372 -.
-
Pull in bushing - A - until 3372/1 is flush with upper edge of removal tool - 3372 -.
Installing front bonded rubber bush
-
Raise installation tool 3372 and take out shell sections -3372/2-.
-
Replace bridge piece -3351/4 with thrust piece -3351/1 - and then pull in bushing until they stop.
Apply corrosion protection if paint surface on subframe is damaged.