A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
Seals and Gaskets: Service and Repair
Shift Rod Oil Seal, Replacing
Shift rod oil seal, replacing, 01J, CVT A/T FWD
Special tools, testers and auxiliary items required
Tube VW 418 A
Work procedure
^
Transmission removed.
-
Remove bolt -B- completely and remove selector shaft lever -A- upward.
-
Carefully pry out selector shaft oil seal lying underneath using a screwdriver.
Note:
^
Sealing surface and selector shaft must not be damaged.
-
Coat outer circumference of new sealing ring with ATF.
-
Slide on new oil seal over selector shaft and press in.
-
Drive oil seal until it stops using tube 31.5 mm dia. VW 418A.
-
Connect selector shaft lever -A- to selector shaft and tighten bolt -B-.
Tightening Torque