A4 Cabriolet Mk2
| Attaching bumper cross member to impact absorber |
Note| t | The impact absorber is self-adjusting, i.e. it can provide compensation for height tolerances between the cross member and the impact absorber when screwing in the bolt. |
| t | In this way, the cross member is automatically held and fixed in the previously set position at the front when screwing in the bolts -1-. |
| 1 - | Bolt |
| q | 23 Nm |
| 2 - | Lower drive bushing |
| q | Plastic part pressed into adjusting screw |
| q | No replacement part |
| 3 - | Lower adjusting screw |
| q | Screw in fully before fitting the bumper cross member but do not tighten. |
| q | Left-hand thread |
| q | No replacement part |
| 4 - | Lower threaded bushing |
| q | Secured with locking pin to stop it falling out |
| q | No replacement part |
| 5 - | Locking pin |
| q | No replacement part |
| 6 - | Impact absorber |
| q | Removing and installing → Chapter |
| 7 - | Upper threaded bushing |
| q | Secured with locking pin to stop it falling out |
| q | No replacement part |
| 8 - | Upper adjusting screw |
| q | Screw in fully before fitting the bumper cross member. |
| q | Right-hand thread |
| q | No replacement part |
| 9 - | Cover |
| q | Removing and installing → Chapter |
| 10 - | Nut |
| q | Part of scope of delivery of cross member |
| 11 - | Upper drive bushing |
| q | Plastic part pressed into adjusting screw |
| q | No replacement part |
| 12 - | Cross member |
