| –
| To remove, warm protective mouldings -1-, -2- or -3- with a hot-air blower and detach. |
| l
| Surface to be bonded must be free from dust and grease. |
| –
| Clean outer panel with petrol, treat with silicone remover and rub dry. |
| l
| Protective mouldings are only to be bonded on at room temperature. |
| l
| This involves allowing vehicle and protective mouldings to adjust to ambient temperature for at least 2 hours prior to performing work. |
| l
| Once backing has been removed, protective moulding must be bonded on within 90 minutes. |
| –
| Detach backing -4- from double-sided adhesive strip -5- shortly before fitting. |
| –
| Fit protective moulding at front and bond on from front to rear. |
| –
| Heat protective moulding with hot-air blower to approx. 40 °C and firmly press or roll on. |
| l
| Vehicle must be kept at ambient temperature for 4 hours after bonding on moulding. |
|
|
|
Note
