A4 Cabriolet Mk2
| Removing and installing control motors for lumbar support adjustment - vehicles from model year 2006 onwards |
| 1 - | Backrest padding |
| 2 - | Lumbar support |
| 3 - | Clamp |
| 4 - | Frame for lumbar support |
| 5 - | Control motor for lumbar support |
| t | Removing |
Note| When renewing the control motor the lumbar support must not be in an end stop position. |
| – | Remove backrest cover panel → Chapter. |
| – | Unplug electrical connector → Fig.. |
| – | Release retaining bracket and take control motor out downwards → Fig.. |
| t | Installing |
| Installation is carried out in the reverse order, note the following: |
| – | The control motor can only be installed in one position. |
| 6 - | Centring pin |
| For centralising lumbar support in lumbar support frame |
| 7 - | Rivet |
| 8 - | Plastic washer |
| 9 - | Control motor for lumbar support height adjustment |
| t | Removing |
Note| When renewing the control motor the lumbar support must not be in an end stop position. |
| – | Remove backrest cover panel → Chapter. |
| – | Unplug electrical connector → Fig.. |
| – | Release retaining bracket and lift out control motor → Fig.. |
| t | Installing |
| Installation is carried out in the reverse order, note the following: |
| – | The control motor can only be installed in one position. |
| 10 - | Fastening strips |
