–
| Release cable bracket, unplug speed sensor connector -1- and press out grommet (left and right sides are the same). |
Installation is carried out in reverse sequence. |
–
| Before installing, lubricate seal for speed sensor all round with lubricating paste -G 000 650-. |
Checking rotor on rear axle |
–
| Unscrew speed sensor from wheel bearing housing. |
–
| Check that rotor is not damaged or dirty. |
Removing and installing rotor on rear axle |
–
| Hang up brake caliper on body. |
–
| Check that rotor is not damaged or dirty. |
–
| If rotor is damaged, remove drive shaft with rotor and renew outer joint. |
Installation is carried out in reverse sequence. |
–
| Route speed sensor wire back in original position - see removal. |
–
| Before installing, lubricate seal for speed sensor all round with lubricating paste -G 000 650-. |
Note t
| If rotor is damaged or dirty, remove drive shaft. If damaged, renew outer C.V. joint together with rotor. |
t
| As replacement part, outer C.V. joint is supplied together with rotor. → Rep. Gr.42 |
|
|
|