A4 Cabriolet Mk2
| Detaching heater elements and air ducts from air conditioner unit/attaching |
| 1 - | Air conditioner unit |
| q | Removing and installing → Chapter |
| q | Dismantling and assembling → Chapter |
| 2 - | Coolant pipe |
| q | Return |
| 3 - | Coolant pipe |
| q | Supply |
| 4 - | Holder for coolant pipes |
| 5 - | Bolt |
| 6 - | Cover for coolant pipes |
| 7 - | Clips |
| q | Replace |
| q | Ensure proper fit |
| q | Bolt tightening torque 2.5 Nm |
| 8 - | Sealing ring |
| q | Replace |
| 9 - | Heating system heat exchanger |
| q | Removing and installing → Chapter |
| 10 - | Cover |
| q | Only fitted on vehicles with air conditioner unit with opening but no auxiliary heater element |
| q | The cover is the same as the end cover for the auxiliary heater element -Z35-, however the connector penetrations are provided with an air-tight seal. |
| 11 - | Auxiliary heater element -Z35- |
| q | Only intended for vehicles with diesel engine not fitted with a fuel-driven supplementary heater → Chapter |
| q | Function, removing and installing → Chapter |
| q | As of the start of 2003, modified heater elements have gradually been introduced (slightly different component width and 6 instead of 7 heater elements). These elements have a different part number, however both versions can be fitted as the air distributor housings are not being modified at present → Parts List |
| 12 - | Sealing plug |
| q | Only fitted on vehicles without “glove box cooling” as optional extra |
| 13 - | Air duct to glove box |
| q | Only fitted on vehicles with “glove box cooling” as optional extra |
| 14 - | Connection for condensate drain |
| q | Leave the condensate drain in the vehicle on removing the air conditioner unit |
