A4 Cabriolet Mk2
Note
|
| 1 - | Compressor drive shaft |
| q | Check; after tightening screw connection, drive shaft must engage snugly in splines of drive gear → Chapter |
| q | Tightening torque 60 Nm |
| q | Slackening off and tightening → Chapter |
| q | Removing and installing → Chapter |
| q | Lubricate drive gear splines with special grease G 000 100 → Parts List |
| 2 - | Hexagon socket-head bolt |
| q | Tightening torque 10 Nm |
| 3 - | Drive plate |
| q | With overload safeguard, tripped in the event of excessive torque (e.g. stiff compressor) and drive shaft just free-wheels without driving compressor |
| q | Checking concentricity and adjusting → Chapter |
| q | Detaching/attaching → Chapter |
| 4 - | Drive plate |
| q | Screwed to compressor drive shaft |
| q | With overload safeguard, tripped in the event of excessive torque (e.g. stiff compressor) and drive shaft just free-wheels without driving compressor |
| q | Tightening torque 30 Nm |
| q | Detaching/attaching → Chapter |
| 5 - | Rubber element |
| q | Isolates drive unit, damps vibration and noise |
| q | On installation, moisten rubber elements slightly with soap solution for example to provide lubrication |
| q | Detaching/attaching → Chapter |
| 6 - | Spacer |
| q | Genuine spacer must be fitted |
| q | Dimensions: 17.5 x 10 x 3 mm |
| 7 - | Circlip |
| q | Replace |
| q | Ensure correct positioning (flat side facing compressor) |
| q | Removing and installing → Chapter |
| 8 - | Drive plate |
| q | With rolling bearing |
| q | Detaching/attaching → Chapter |
| q | Clean flange of compressor before fitting drive plate |
| 9 - | Compressor |
| q | Different models may be fitted depending on engine and country version → Parts List |
