audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive wheel for speedometer sender > < Renewing flange shaft oil seal (left and right)

A4 Cabriolet Mk2

Removing and installing speedometer senderG22
Removing and installing speedometer sender -G22-
  Note
Speedometer sender -G22- and drive wheel are not fitted on vehicles from 07.2002 onwards. The bore for speedometer sender -G22- is sealed with a sealing plug.
Removing
l  Gearbox in vehicle
–  Please observe general repair instructions → Chapter.
   
–  If fitted, loosen quick-release fasteners -2- and -3- and remove rear noise insulation -B-.
  A34-0530
–  Unplug connector from speedometer sender-A-.
–  Press down retainer, swivel speedometer sender aside and take out upwards.
Installing
  V34-2357
–  Install new O-ring -B-.
–  Insert speedometer sender-A- and engage.
–  Take care not to damage speedometer sender. Speedometer reading may be inaccurate if sender is damaged.
–  Install rear noise insulation (if fitted).
  V34-2357

Removing and installing drive wheel for speedometer sender > < Renewing flange shaft oil seal (left and right)