A4 Cabriolet Mk2
| Removing and installing input shaft, pinion shaft, hollow shaft, selector rods, gearbox cover and cover with centre differential |
| 1 - | Gearbox housing |
| 2 - | Input shaft |
| q | Dismantling and assembling → Chapter |
| q | Adjusting → Chapter |
| q | Servicing bearings for input shaft → Chapter |
| 3 - | Selector rod with selector fork for 3rd and 4th gear |
| q | Dismantling and assembling → Chapter |
| q | Renewing bearing bushes → Chapter |
| 4 - | Stop bolt (left-side) |
| q | 40 Nm |
| 5 - | Washer |
| 6 - | Relay shaft |
| q | Installation position → Item |
| 7 - | Washer |
| 8 - | Stop bolt (right-side) |
| q | 40 Nm |
| 9 - | Selector shaft |
| q | Installation position → Item |
| q | Renewing selector shaft oil seal → Item |
| 10 - | Detent segment |
| q | Installation position |
| 11 - | TORX bolt |
| q | 25 Nm |
| q | With collar to secure detent segment spring |
| 12 - | Selector rod with 1st/2nd/5th and reverse gear selector forks |
| q | Dismantling and assembling → Chapter |
| q | Removing and installing ball sleeves → Fig. |
| 13 - | pinion shaft with hollow shaft |
| q | Dismantling and assembling → Chapter |
| q | Adjusting → Chapter |
| q | Servicing bearings for pinion shaft and hollow shaft → Chapter |
| 14 - | Gearbox cover |
| q | Removing and installing oil collector → Fig. |
| 15 - | TORX bolt |
| q | 22 Nm |
| 16 - | Spring |
| 17 - | Cover with centre differential |
| q | Removing and installing with gearbox installed → Chapter |
| q | Removing and installing centre differential in cover → Chapter |
| q | Servicing cover → Chapter |
| 18 - | TORX bolt |
| q | 22 Nm |
