Audi Workshop Service and Repair Manuals > A4 Cabriolet Mk2 > Power transmission | 6-speed manual gearbox 01E, four-wheel drive | Final drive, differential, differential lock | Servicing front final drive | Removing and installing speedometer sender G22

Removing and installing speedometer senderG22

Removing and installing speedometer sender -G22-

Note

Speedometer sender -G22- and drive wheel are not fitted on vehicles from 07.2002 onwards. The bore for -G22- is sealed with a sealing plug.

Removing

l	Gearbox in vehicle

–	Remove front left wheel.

Vehicles with V6 engine:

–	Unbolt heat shield for left-side drive shaft -arrows-.

–	Unplug electrical connector at speedometer sender -G22--item B-.

–	Push down the retaining clip holding the speedometer sender -G22-, turn it, and pull out the sender.

Installing

–	Renew O-ring -A-.

–	Take care not to damage speedometer sender -G22-. Speedometer reading may be inaccurate if sender is damaged.

Vehicles with V6 engine:

–	Install heat shield for drive shaft.

Tightening torque

Components	Nm
Heat shield for drive shaft to gearbox	23

Audi Workshop Service and Repair Manuals