A4 Cabriolet Mk2
5th and 6th gear - exploded view |
1 - | 1st inner race for input shaft ball bearing |
q | Pulling off → Anchor |
q | Driving on → Anchor |
2 - | Needle bearing for 5th gear |
3 - | Inner race for 5th speed selector gear |
q | Pulling off → Anchor |
q | Driving on → Anchor |
4 - | 5th speed selector gear |
q | Pulling off → Anchor |
q | Installing → Anchor |
5 - | Roll pin |
q | Pressing out → Anchor |
q | Pressing in → Anchor |
6 - | Follower for 5th and 6th gear |
q | Only renew complete with selector rod for 5th and 6th gear → Item |
q | Pulling off → Anchor |
q | Fitting → Anchor |
7 - | Selector fork for 5th and 6th gear |
q | Can be renewed individually |
8 - | Selector rod for 5th and 6th gear |
q | Only renew complete with follower for 5th and 6th gear → Item |
q | Removing → Anchor |
q | Installing → Anchor |
9 - | Locking collar, synchro-ring, synchronising hub for 5th and 6th gear |
q | Removing → Anchor |
q | Installing → Anchor |
10 - | Circlip |
q | Re-determining thickness → Anchor |
11 - | 5th gear wheel |
q | Pulling off → Anchor |
q | Driving on → Anchor |
12 - | 6th speed selector gear |
q | Pull off together with synchronising hub and inner race for 5th gear → Anchor |
13 - | Needle bearing for 6th gear |
14 - | Thrust washer |
q | For needle bearing for 6th speed selector gear |
q | Installation position: groove faces circlip, smooth contact surface towards needle bearing |
15 - | Circlip |
16 - | Inner race for roller bearing |
q | Take off by hand → Anchor |
17 - | Shim |
q | Re-determining thickness → Anchor |
18 - | Spacer sleeve |
q | Length 39.6 mm |
19 - | 6th gear wheel |
q | Remove intermediate housing with gear cluster before pressing off → Anchor |
q | Pressing off → Anchor |
q | Pressing on → Anchor |