A4 Cabriolet Mk2
Exploded view - servicing clutch release mechanism |
Special tools and workshop equipment required |
t | Thrust plate -VW 402- |
t | Press tool -VW 412- |
t | Press tool -VW 454- |
t | Torque wrench -V.A.G 1331- |
t | -1-Internal puller -Kukko 21/5- |
t | -4-Counter-support -Kukko 22/1- |
t | Sealing grease -G 052 128 A1- |
t | Adhesive -AMV 195 KD1 01- |
t | Copper grease (commercially available) |
1 - | Clutch slave cylinder |
q | Removing and installing → Chapter |
q | Do not operate clutch pedal after slave cylinder has been removed |
q | When installing, push in until the securing bolt → Item can be fitted |
q | Bleeding clutch system → Chapter |
q | Tighten bleeder valve to 4.5 Nm |
2 - | Hexagon socket head bolt |
q | 23 Nm |
q | Clutch slave cylinder to gearbox |
q | Self-locking |
q | Always renew |
3 - | Bracket |
q | For pipe/hose assembly |
q | Bolt to gearbox with clutch slave cylinder |
4 - | Plunger |
q | Lubricate end of plunger with copper grease (commercially available) |
5 - | O-ring |
q | Always renew → Fig. |
q | Lubricate with gear oil before installing |
6 - | Oil seal |
q | For input shaft |
q | Pull out of guide sleeve → Item → Fig.. |
q | Installation depth → Fig. |
q | Press into guide sleeve → Item → Fig.. |
q | Pack space between sealing lip and dust lip half full with sealing grease -G 052 128 A1- |
7 - | Guide sleeve |
q | Removing and installing → Fig. |
q | Before removing and installing, cover input shaft splines with a shrink-fit hose to protect oil seal |
8 - | Clutch release lever |
q | Removing and installing → Fig. |
q | Before installing, lubricate area which makes contact with plunger of slave cylinder with copper grease (commercially available). |
9 - | Release bearing |
q | Do not wash out; wipe clean only |
q | Renew bearing if noisy |
q | Servicing release bearing with glued plastic ring → Fig. |
q | Checking release bearing with mechanically attached plastic ring → Fig. |
q | Renew if groove worn on plastic ring is too deep → Fig. |
q | Retainer lugs on release bearing must engage in release lever |
10 - | Bolt |
q | 24 Nm |
q | Self-locking |
q | Before installing bolt, clean thread with wire brush and then apply locking fluid -AMV 185 101 A1- |
11 - | Leaf spring |
12 - | Bolt |
q | 24 Nm |
q | Self-locking |
q | Before installing bolt, clean thread with wire brush and then apply locking fluid -AMV 185 101 A1- |
13 - | Retaining piece |
q | For guide sleeve |
q | Removing and installing → Fig. |
14 - | Intermediate piece |
q | Renew if damaged |
15 - | Gearbox |
|
|
|
|
|
|
|