A4 Cabriolet Mk2
| Exploded view - selector mechanism cover, selector lever handle |
WARNING
|
Note| Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
| 1 - | Selector lever |
| 2 - | Sleeve for selector lever |
| q | Removing and installing → Chapter „Removing and installing selector lever handle“ |
| 3 - | Selector lever handle |
| q | Removing and installing → Chapter |
| 4 - | Cover |
| q | With selector indicator and tiptronic gate |
| q | Removing and installing → Chapter „Removing and installing tiptronic switch -F189-“ and in addition unclip symbol panel |
| 5 - | Symbol insert |
| q | Clipped onto cover |
| 6 - | Printed circuit |
| q | With integrated tiptronic switch -F189- |
| q | Removing and installing → Chapter „Removing and installing tiptronic switch -F189-“ |
| q | Switch consists of 3 Hall sensors, which are activated by a magnet on the transverse slide of the sliding cover. |
| q | In the event of faults, first check that magnet is properly secured on transverse slide of sliding cover → Item, renew sliding cover if necessary. |
| q | Before renewing printed circuit when fault memory indicates fault code “18161”, first check adjustment of selector lever cable → Chapter |
| 7 - | Sliding cover |
| q | With integrated magnet for tiptronic switch -F189- on transverse slide. |
| q | Removing and installing → Chapter „Removing and installing tiptronic switch -F189-“ |
| 8 - | Guide for sliding cover |
