audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Cleaning ATF cooling pipes and ATF cooler > < Exploded view - ATF cooling pipes on vehicles with 3.0 ltr. TDI engine

A4 Cabriolet Mk2

Removing and installing ATF cooling pipes
Removing and installing ATF cooling pipes
Special tools and workshop equipment required
t  Drip tray
t  Safety goggles
  Note
t  Rules for cleanliness when working on the automatic gearbox → Chapter.
t  Thoroughly clean all joints and connections and the surrounding areas before dismantling.
Removing
–  Mark position of all ATF cooling pipes in relation to one another with different colours to avoid confusion.
–  Place drip tray -V.A.G 1306- underneath.
  WARNING
Wear safety goggles.
–  Disconnect ATF cooling pipes.
–  Seal opened cooling pipes with clean sealing plugs.
Installing
Installation is carried out in reverse sequence; note the following:
–  Clean ATF pipes → Chapter.
–  Renew O-rings and lubricate them lightly with ATF.
–  First push ATF pipes into gearbox or cooler by hand onto stop, then secure pipes → Chapter „Exploded view - ATF cooling pipes on vehicles with 4.2 ltr. MPI engine“.
–  Check ATF level → Chapter.
   

Cleaning ATF cooling pipes and ATF cooler > < Exploded view - ATF cooling pipes on vehicles with 3.0 ltr. TDI engine