Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing mechatronic unit >
< Removing and installing oil pan
A4 Cabriolet Mk2
Power transmission
Automatic gearbox 09L, four-wheel drive
Automatic gearbox, gears, control / Removing and installing oil pan, ATF strainer and mechatronic unit
Removing and installing ATF strainer
Removing and installing ATF strainer
Removing and installing ATF strainer
Removing
Note
t
General repair instructions
→ Chapter
.
t
Rules for cleanliness when working on the automatic gearbox
→ Chapter
.
–
Remove oil pan
→ Chapter
.
–
Carefully remove ATF strainer
-A-
from gearbox.
Installation is carried out in reverse sequence; note the following:
Note
The ATF strainer only has to be renewed if it has been damaged.
Note the following when renewing ATF strainer:
–
If fitted, carefully remove oil seal for ATF strainer
-A-
from gearbox using a screwdriver or similar.
Note
t
Take care not to damage sealing surface.
t
For illustration purposes the oil seal is shown with mechatronic unit removed.
t
The new ATF strainer is supplied with oil seal fitted.
Continuation for new and old ATF strainer:
–
Press intake pipe of ATF strainer
-A-
carefully onto stop into mounting hole in gearbox.
Note
A new ATF strainer is pressed into gearbox with oil seal fitted.
–
Install oil pan
→ Chapter
.
–
Fill up with ATF
→ Chapter
.
Power transmission
Automatic gearbox 09L, four-wheel drive
Automatic gearbox, gears, control / Removing and installing oil pan, ATF strainer and mechatronic unit
Removing and installing ATF strainer
Removing and installing mechatronic unit >
< Removing and installing oil pan