audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking torque converter > < Draining torque converter

A4 Cabriolet Mk2

Renewing oil seal for torque converter
Renewing oil seal for torque converter
Special tools and workshop equipment required
   
t  Oil seal extractor lever -VW 681-
  W00-0154
t  Thrust piece -T10137-
Procedure
–  Remove gearbox: → Chapter „Removing gearbox - vehicles with 2.0 ltr. TFSI engine“, → Chapter „Removing gearbox on vehicles with 3.2 ltr. FSI engine“, → Chapter „Removing gearbox on vehicles with 4.2 ltr. MPI engine“ or → Chapter „Removing gearbox on vehicles with 3.0 ltr. TDI engine“.
–  Mount gearbox on assembly stand → Chapter.
–  Carefully pull out torque converter.
  W00-1330
–  Remove oil seal for torque converter using oil seal extractor lever -VW 681-.
–  Lightly lubricate outer circumference and sealing lips of oil seal with ATF.
l  Installation position: open side of oil seal points towards gearbox
  A32-0002
–  Drive in torque converter oil seal with thrust piece -T10137- until thrust piece reaches stop.
  A32-0012

Checking torque converter > < Draining torque converter