audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view - Dismantling and assembling selector mechanism (vehicles up to VIN 8E_6A156499) > < Removing and installing selector mechanism cover (vehicles up to VIN 8E_6A156499)

A4 Cabriolet Mk2

Removing and installing tiptronic switchF189 (vehicles up to VIN 8E_6A156499)
Removing and installing tiptronic switch -F189- (vehicles up to VIN 8E_6A156499)
  Note
t  In order to renew the tiptronic switch -F189-, the printed circuit → Item must be renewed.
t  If malfunctions occur in the tiptronic switch -F189-, first check that the magnet on the transverse slide of the sliding cover is secured properly. If necessary, renew sliding cover. The printed circuit should only be renewed after the wiring has been checked.
   
Removing
–  Remove selector mechanism cover → Chapter.
–  Press down the locking hooks -arrows- and pull the cover -2- off the guide -1-.
–  Remove printed circuit with integrated tiptronic switch -F189-.
  A37-0464
–  Check magnets -arrows- on sliding cover for firm attachment.
l  If a magnet is missing, sliding cover must be renewed
Installing
Installation is carried out in reverse sequence; note the following:
–  Install selector mechanism cover → Chapter.
  A37-10845

Exploded view - Dismantling and assembling selector mechanism (vehicles up to VIN 8E_6A156499) > < Removing and installing selector mechanism cover (vehicles up to VIN 8E_6A156499)