audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Final drive, differential, differential lock > < Removing and installing ATF filter

A4 Cabriolet Mk2

Removing and installing suction-jet pump
Removing and installing suction-jet pump
   
Removing
Proceed as follows:
–  Remove input shaft → Chapter.
–  Remove chain and pulley set “I” → Chapter.
–  Pull off oil pipe -1-.
–  Remove O-ring -2- from oil pipe.
  A37-10761
–  Remove bolts -arrows-.
  A37-10762
–  Pull suction-jet pump out of guide and then pull slightly to the side -arrow 1-.
–  Tilt suction-jet pump out of retainer -arrow 2-.
  A37-10763
–  Lift out suction-jet pump -arrow 3-.
Installing
l  Tightening torques → Chapter
Perform installation in reverse sequence of removal.
  A37-10764

Final drive, differential, differential lock > < Removing and installing ATF filter