Remaining installation steps are carried out in reverse sequence; note the following: |
–
| Install engine mountings free of stress. To do so, shake engine before tightening engine mountings. |
–
| Install exhaust system and align free of stress → Chapter. |
Caution Do not use a battery charger to boost starting. There is danger of damaging the vehicle's control units. |
|
Note t
| Drained-off coolant may only be used again if the original cylinder head and cylinder block are re-installed. |
t
| Contaminated or dirty coolant must not be used again. |
Vehicles with multitronic gearbox: |
Note t
| Tightening torques apply only to lightly greased, oiled, phosphated or black-finished nuts and bolts. |
t
| Additional lubricant such as engine oil or gearbox oil may be used, but do not use lubricant containing graphite. |
t
| Do not use degreased parts. |
t
| Tolerance for tightening torques ± 15 %. |
|
|
|