A4 Cabriolet Mk2
1 - | 10 Nm |
2 - | Toothed belt cover (top) |
3 - | 50 Nm + 180° |
q | Renew |
q | Use counterhold tool -3036- when loosening and tightening → Fig. |
4 - | Camshaft sprocket |
q | Remove toothed belt prior to removing and installing → Chapter |
q | Installation position fixed by Woodruff key → Item |
q | Detaching camshaft sprocket → Fig. |
5 - | 10 Nm |
q | Apply locking fluid when fitting |
q | Locking fluid → Parts catalogue |
6 - | Toothed belt cover (rear) |
7 - | Woodruff key |
q | Check for firm attachment |
8 - | 25 Nm |
9 - | Semi-automatic tensioning roller |
10 - | Coolant pump |
q | Removing and installing → Chapter |
11 - | O-ring |
q | Renew |
12 - | 25 Nm |
13 - | Damper wheel |
14 - | 15 Nm |
15 - | 35 Nm |
16 - | Damper wheel |
17 - | Sealing flange |
q | Removing and installing → Chapter |
18 - | Diamond-coated washer for toothed belt sprocket |
q | Renew washer if toothed belt sprocket is removed |
19 - | Crankshaft sprocket |
q | Contact surface between sprocket and crankshaft must be free of oil |
q | Can only be installed in one position |
20 - | 90 Nm + 90° (1/4 turn) further |
q | Renew |
q | Do not lubricate with oil |
q | Attaching counterhold tool 3415 → Fig. |
21 - | Toothed belt |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen |
q | Check for wear |
q | Removing → Chapter |
q | Installing (adjusting valve timing) → Chapter |
22 - | Toothed belt cover (bottom) |
23 - | Cap for toothed belt cover |
|
|
|