A4 Cabriolet Mk2
| Removing and installing sealing flanges and flywheel/drive plate |
Note| t | Servicing clutch: |
| t | Observe instructions for removing the clutch → Rep. Gr.30. |
| t | 6-speed manual gearbox 02S; Repair group 30; Servicing clutch release mechanism |
| 1 - | 15 Nm |
| 2 - | Oil seal |
| q | Renewing → Chapter |
| q | Do not lubricate with oil |
| 3 - | Sealing flange (front) |
| q | Must be positioned on dowel sleeves |
| q | Removing and installing → Chapter |
| 4 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 5 - | Securing bolt for dual-mass flywheel/drive plate |
| q | Renew |
| q | Tightening torque for dual-mass flywheel → Anchor |
| q | Tightening torque for drive plate → Anchor |
| 6 - | Dual-mass flywheel/drive plate |
| q | Removing and installing dual-mass flywheel → Chapter |
| q | Removing and installing drive plate → Chapter |
| q | Can only be installed in one position. Holes are off-set |
| 7 - | Intermediate plate |
| q | Must be positioned on dowel sleeves |
| q | Do not damage/bend when assembling |
| q | Is fitted onto sealing flange → Fig. |
| 8 - | 15 Nm |
| 9 - | Sealing flange with oil seal (rear) |
| q | Renew only as complete unit |
| q | Use guide sleeve provided when fitting |
| q | Do not lubricate/grease sealing lip of oil seal |
| q | Before installing, remove oil residue from crankshaft journal with a clean cloth |
| q | Guide sleeve is not to be removed until sealing flange has been slipped onto crankshaft journal |
|
|
