–
| Connect oil pressure tester -V.A.G 1342- with adapter -V.A.G 1342/14- to bore for oil pressure switch. |
–
| Screw oil pressure switch -2- into oil pressure tester -V.A.G 1342-. |
–
| Connect brown wire of oil pressure tester to earth („–“). |
Checking oil pressure switch |
–
| Connect voltage tester -V.A.G 1527 B--item 1- with adapter leads from auxiliary measuring set -V.A.G 1594 C- to oil pressure switch and battery positive („+“). |
l
| LED should not light up. |
–
| Renew oil pressure switch. |
Note Observe tester and LED while starting, as switching point of oil pressure switch may already be exceeded when starting. |
l
| LED should light up at 1.2 ... 1.6 bar. |
If LED does not light up: |
–
| Renew oil pressure switch. |
l
| Minimum oil pressure at 2000 rpm: 1.3 bar. |
l
| Minimum oil pressure at 3500 rpm: 3.5 … 4.5 bar. |
The pressure relief valve or oil pump is defective if the specifications are not attained. |
Installation is carried out in the reverse order; note the following: |
Note Renew seal when installing oil pressure switch. |
|
|
|