A4 Cabriolet Mk2
Poly V-belt drive - exploded view |
1 - | Poly V-belt |
q | Check for wear |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
q | Removing and installing → Chapter |
q | When installing, make sure it is properly seated on pulleys. |
2 - | Vibration damper |
q | With pulley for poly V-belt |
q | Can only be installed in one position |
q | Removing and installing → Chapter |
3 - | 10 Nm + 90° (1/4 turn) further |
q | Renew |
4 - | Cover cap for vibration damper |
5 - | 23 Nm |
6 - | Pulley for power steering pump |
q | Counterhold with drift to unbolt |
7 - | Poly V-belt tensioner |
q | Use locking pin -T10060 A- to lock tensioner. |
q | Removing and installing → Chapter |
8 - | Dowel sleeve |
q | Ensure correct seating in bracket |
9 - | 40 Nm + 90° (1/4 turn) further |
q | Renew |
10 - | Idler roller for toothed belt |
11 - | Bracket for ancillaries |
q | Removing and installing → Chapter |
12 - | 23 Nm |
13 - | Alternator |
q | Removing and installing → Rep. Gr.27 |
q | To facilitate attachment of alternator, knock back threaded bushes for securing bolts slightly |
14 - | 23 Nm |
15 - | 23 Nm |
16 - | Power steering pump |
q | Removing and installing → Rep. Gr.48 |
q | To facilitate attachment of power steering pump, knock back threaded bush for securing bolt slightly |
17 - | 45 Nm |
18 - | Dowel sleeve |
q | 2x |
q | Ensure correct seating in bracket for ancillaries |
19 - | Air conditioner compressor |
q | Do not unscrew or disconnect refrigerant hoses or pipes. |
q | Removing and installing → Rep. Gr.87 |
q | Pay attention to dowel sleeves → Item when installing |
20 - | 25 Nm |
21 - | 23 Nm |
22 - | Idler roller for poly V-belt |
q | Note installation position |
23 - | 20 Nm + 90° (1/4 turn) further |
q | Renew |
24 - | Cover cap for idler roller |