audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant pipe (rear) > < Removing and installing coolant pipe (front)

A4 Cabriolet Mk2

Removing and installing coolant pipe (right-side)
Removing and installing coolant pipe (right-side)
   
Removing
–  Remove intake manifold → Chapter.
–  Disconnect rear coolant hose -2- from coolant pipe (right-side).
–  Remove bolt -1-.
–  Pull coolant pipe (right-side) out of cylinder block towards the rear -arrow-.
–  Take out coolant pipe from the top.
Installing
Installation is carried out in the reverse order; note the following:
  Note
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue
t  Renew O-rings.
–  Clean and smoothen sealing surface for O-ring as required.
–  Lubricate new O-ring with “G12+” and slide onto coolant pipe.
–  Slide coolant pipe into bore in cylinder block.
–  Install intake manifold → Chapter.
–  Fill cooling system → Anchor.
Tightening torque
  A19-0309
ComponentNm
Coolant pipe (right-side) to cylinder block10

   

Removing and installing coolant pipe (rear) > < Removing and installing coolant pipe (front)