Audi Workshop Service and Repair Manuals

Renewing crankshaft oil seal (gearbox end) Special tools and workshop equipment required

t  Fitting tool -T10122-

t  Extractor tool -T20143-

Procedure l  Engine/gearbox removed. –  Remove dual-mass flywheel (vehicles with manual gearbox) → Chapter. –  Remove flywheel (on a vehicle with multitronic gearbox → Chapter). –  Remove drive plate (vehicles with automatic gearbox) → Chapter. –  Pry out oil seal using extractor tool -T20143/2-.

–  Modify assembly sleeve -T10122/2- by drilling an 8 mm Ø hole -arrow 2- for the dowel sleeve. –  Use hole -arrow 1- in washer as a drilling template.

–  Clean running surface and sealing surface. –  Fit assembly aid -T10122/1- onto assembly sleeve -T10122/2- and slide oil seal -A- onto assembly sleeve. –  Take off assembly aid.

–  Fit assembly sleeve with oil seal onto crankshaft.

–  Press in the oil seal with thrust sleeve -T10122/3- evenly so that it is flush all round. –  Install dual-mass flywheel (vehicles with manual gearbox) → Chapter. –  Install flywheel (on a vehicle with multitronic gearbox → Chapter). –  Install drive plate (vehicles with automatic gearbox) → Chapter.