A4 Cabriolet Mk2
| Intake manifold - exploded view |
| 1 - | Vacuum unit |
| q | For actuation of intake manifold flap |
| q | Right cylinder bank |
| 2 - | Bolt |
| q | 9 Nm |
| 3 - | Pivot pin |
| 4 - | Bracket |
| 5 - | Intake manifold flap valve -N316- |
| 6 - | Bolt |
| q | 9 Nm |
| 7 - | Intake manifold flap potentiometer -G336- |
| q | After renewing, perform “Adaption” in “Guided Functions” mode, vehicle diagnostic, testing and information system -VAS 5051B- |
| 8 - | Bolt |
| q | 2.5 Nm |
| 9 - | O-ring |
| q | Renew |
| 10 - | Throttle valve module -J338- |
| q | After renewing, perform “Adaption” in “Guided Functions” mode, vehicle diagnostic, testing and information system -VAS 5051B- |
| 11 - | Bolt |
| q | 9 Nm |
| 12 - | Gasket |
| q | Renew |
| 13 - | Intake manifold |
| q | Removing and installing → Chapter |
| 14 - | Bolt |
| q | 2.5 Nm |
| 15 - | Intake manifold flap potentiometer 2 -G512- |
| q | After renewing, perform “Adaption” in “Guided Functions” mode, vehicle diagnostic, testing and information system -VAS 5051B- |
| 16 - | O-ring |
| q | Renew |
| 17 - | Bolts |
| q | Tighten in 3 stages and in diagonal sequence |
| q | 1st stage: Tighten to 5 Nm |
| q | 2nd stage: Now tighten to 9 Nm |
| q | 3rd stage: Tighten to 9 Nm again |
| 18 - | Intake manifold gasket |
| q | Renew |
| 19 - | Vacuum unit |
| q | For actuation of intake manifold flap |
| q | Left cylinder bank |
| 20 - | Pivot pin |
| 21 - | Bolt |
| q | 9 Nm |
