audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Adjusting toe-in curve at front wheels > < Adjusting camber at rear wheels

A4 Cabriolet Mk2

Adjusting toe setting at rear wheels
Adjusting toe setting at rear wheels
   
–  Remove underbody trim -1- in front of trapezium link. → Rep. Gr.66
  A42-0331
Cabriolet models only
–  Remove diagonal strut -1- or -2- on the side where toe adjustment is required → Chapter.
  A42-0330
All vehicles (continued):
–  Remove nut -C- on bolt connection between trapezium link (inside, front) and subframe.
–  Adjust toe as required by turning eccentric bolt -D-.
–  Fit and tighten new nut -C- → Item.
  Note
t  The maximum adjustment range is 90° to the left or right of the centre position.
t  Adjusting the individual toe settings automatically alters the geometric running direction of the axle.
–  Check toe setting again after tightening nut -C-.
Cabriolet models only
–  Install diagonal strut → Chapter.
All vehicles (continued):
–  Install underbody trim. → Rep. Gr.66
  A44-0129

Adjusting toe-in curve at front wheels > < Adjusting camber at rear wheels