Audi Workshop Service and Repair Manuals > A4 Cabriolet Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Rear lights - vehicles up to model year 2006 | Removing and installing rear light and bulb carrier

Removing and installing rear light and bulb carrier

Removing

–	Turn cap in luggage compartment trim to left -arrow- and remove.

–	Remove bolt -1-.

Note

t	Rear light (outer) cannot be removed until bolt has been taken out.

t	Do not slacken -item 2- when removing rear light.

–	Slide rear light outwards -arrows- and disengage from retaining pins at body.

–	Unplug electrical connector at rear light.

–

–	Turn bulb holder anti-clockwise -arrow- and pull out of housing.

–	Screw bulb out of bulb holder.

Installing

Installation is carried out in the reverse order; note the following:

Note

Ensure that seal between body and rear light housing seals completely.

–	Position rear light in place at retaining pins (from outside) and press on towards centre of vehicle until it engages.

Tightening torque

Component	Nm
Rear light to body	6

Audi Workshop Service and Repair Manuals