–
| Guide free connector -2- (blue) at wiring harness through free chamber of switch insert from rear. |
–
| Plug in connector -2- at warning lamp for airbag deactivated on front passenger side -K145--1-. |
–
| Make sure connector -2- and warning lamp for airbag deactivated on front passenger side -K145--1- engage properly (audibly). |
–
| Insert warning lamp for airbag deactivated on front passenger side -K145--1- in dash panel switch mounting and engage. |
–
| Clip in trim for switch module at top. |
WARNING Make sure nobody is in the vehicle when the battery is being connected. |
|
–
| Re-code airbag control unit -J234- → Chapter. |
–
| Perform functional test. |
–
| Deactivate airbag on front passenger side with key-operated switch to deactivate airbag on front passenger side -E224-. |
| Warning lamp for airbag deactivated on front passenger side -K145- must light up constantly. |
–
| Activate airbag on front passenger side with key-operated switch to deactivate airbag on front passenger side -E224-. |
| Warning lamp for airbag deactivated on front passenger side -K145- must go out. |
–
| Interrogate and erase fault memories of all control units. To do so, use a suitable vehicle diagnostic, testing and information system, e.g. vehicle diagnostic, testing and information system -VAS 5051B-. |
Vehicles with large radio slot |
|
|
|