audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Installing warning lamp for airbag deactivated on front passenger side K145 (from approx. week 45/2003 onwards) > < Removing front interior light W1 without warning lamp for airbag deactivated on front passenger side (up to approx. week 44/20
Installing front interior lightW1 with warning lamp for airbag deactivated on front passenger side (up to approx. week 44/2003)
Installing front interior light -W1- with warning lamp for airbag deactivated on front passenger side (up to approx. week 44/2003)
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1783-
  Note
The wiring to the warning lamp for airbag deactivated on front passenger side -K145- (“PASSENGER AIRBAG OFF” lamp) is part of the front interior light -W1- wiring harness.
–  Locate the wiring harness for the warning lamp for airbag deactivated on front passenger side -K145- (“PASSENGER AIRBAG OFF” lamp) in the area of the headliner opening.
–  Plug in connectors for front interior light -W1- with warning lamp for airbag deactivated on front passenger side -K145- and, if fitted, for hands-free microphone.
  W00-0990
–  Engage front interior light -W1- and secure -arrows-.
–  Press on reading light cover panel until it engages.
–  Switch on ignition.
  WARNING
Make sure nobody is in the vehicle when the battery is being connected.
–  Connect battery earth strap → Electrical system; Rep. Gr.27.
–  Observe measures to be taken after connecting the battery → Electrical system; Rep. Gr.27.
–  Re-code airbag control unit -J234- → Chapter.
–  Perform functional test.
–  Deactivate airbag on front passenger side with key-operated switch to deactivate airbag on front passenger side -E224-.
   Warning lamp for airbag deactivated on front passenger side -K145- must light up constantly.
–  Activate airbag on front passenger side with key-operated switch to deactivate airbag on front passenger side -E224-.
   Warning lamp for airbag deactivated on front passenger side -K145- must go out.
–  Interrogate and erase fault memories of all control units. To do so, use a suitable vehicle diagnostic, testing and information system, e.g. vehicle diagnostic, testing and information system -VAS 5051B-.
Tightening torque
  A96-0669
ComponentNm
Front interior light -W1- to roof3

   

Installing warning lamp for airbag deactivated on front passenger side K145 (from approx. week 45/2003 onwards) > < Removing front interior light W1 without warning lamp for airbag deactivated on front passenger side (up to approx. week 44/20