Audi Workshop Service and Repair Manuals

• Bumper
• ◆ To remove, unscrew combi bolts -6-.
• ◆ On S4 models, you must remove an additional screw on the wheel housing liner
• ◆ Unclip bumper in direction of arrow from bracket -4- and detach to rear.
• Spoiler
• ◆ Removing and installing
• Self-tapping screw
• ◆ 1.5 Nm
• Rear bumper bracket
• ◆ The bumper is in two parts, the length of the front half can be adjusted.

• Clip
• ◆ Press in wing on installation.
• Combi bolt
• ◆ 23 Nm
• Impact absorber
• ◆ Removing from bumper => Page 63-14

Fig.1    → Additional attachments for S4

• ‒ Before dismantling the bumper -1-, unscrew the screws -2- from the wheel housing liner.
• ‒ Clip -4- is attached to the wheel housing liner-3-.

Fig.1    → Removing impact absorber from bumper

• ‒ Unscrew bolts -arrows- and take impact absorber -1- out of bumper -2-.
• ‒ On installation, tighten to 23 Nm.